DAPAudio EDGE EBT-1, Руководство пользователя, Страница: 12 / 20

11
EDGE EBT-1
Product code: D1478B
Connecting Headset/Microphone/Instrument
The device has a 4-pin connector, to connect a headset, microphone or an instrument.
Plug the device of your choice into the 4-pin mini XLR connector IN (08).
Switching ON/OFF
The device has a power button.
Press and hold down the power button (03) for 2 seconds to switch the device on/off.
Pairing
You can pair the device with the receiver.
Before pairing, scan for unused frequencies to avoid interference. Refer to the user manual of the
receiver.
To automatically pair the receiver with the device, follow the steps below:
Put the device near the receiver, so that the IR sensor (09) is as close as possible to the IR sensor of
the receiver.
Pair the receiver with the device. Refer to the user manual of the receiver.
To manually set the device and the receiver to the same channel and frequency, follow the steps below:
Select a group, channel and frequency on the receiver. Refer to the user manual of the receiver.
Follow the steps in 5.1. Control Panel on page 12.
Installation of the Bodypack
Use the belt clip (06) on the device to fasten it to your clothes. Flip the belt clip (06) for best comfort. The
antenna (01) shall always point upwards.
Fig. 08