DAPAudio DSA-250, Инструкция по эксплуатации

Страница: 5 / 19

3
 Only use system indoor, avoid contact with water or other liquids.
 Avoid flames and do not put close to flammable liquids or gases.
 Always disconnect power from the mains, when system is not used. Only handle the power-cord
by the plug. Never pull out the plug by tugging the power-cord.
 Make sure you don’t use the wrong kind of cables or defective cables.
 Make sure that the signals into the mixer are balanced, otherwise hum could be created.
 Make sure you use DI boxes to balance unbalanced signals; All incoming signals should be clear.
 Make sure that the available voltage is not higher than stated on the rear panel.
 Make sure that the power-cord is never crimped or damaged. Check the system and the power-
cord from time to time.
 Make sure that the amplifier is turned down, before turning the power on or off. So you can avoid
supersonic frequencies, which could damage your speakers.
 Don't put your equipment next to TV, radio, etc., because of interference or distortion.
 If you connect other parts of the system, be careful of ground loops.
 Before changing the ground, always turn off your amplifier.
 Please read this manual carefully and keep it for future reference. Remember that the amplifier
has a better value on the market, if you save the carton and all packing materials.
 Connecting amplifier outputs to oscilloscopes or other test equipment, while the amplifier is in
bridged mode, may damage both the amplifier and test equipment.
 Do not drive the inputs with a signal level bigger, than required to drive the equipment to full
output.
 Please turn off the power switch, when changing the power cord or signal cable, or select the
input mode switch.
 In typical use, please set the volume at 0dB position.
 Sometimes, when you want to send one signal to more than one amplifier, you should use a signal
distributor.
 If your Dap Audio device fails to work properly, discontinue use immediately. Pack the unit
securely (preferably in the original packing material), and return it to your Dap Audio dealer for
service.
 Allow time to cool down, before cleaning or servicing.
 For replacement use fuses of same type and rating only.
 Prevent distortion! Make sure that all components connected to the DSA have sufficient power
ratings. Otherwise distortion will be generated because the components are operated at their
limits.
 Avoid ground loops! Always be sure to connect the power amps and the mixing console to the
same electrical circuit to ensure the same phase!
 If system is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
 If the system has been exposed to drastic temperature fluctuation (e.g. after transportation), do
not switch it on immediately. The arising condensation water might damage your system. Leave
the system switched off until it has reached room temperature.
 This device falls under protection class I. Therefore it is essential to connect the yellow/green
conductor to earth.
 Repairs, servicing and electric connection must be carried out by a qualified technician.
OPERATING DETERMINATIONS
This system is not designed for permanent operation. Consistent operation breaks will ensure that the
system will serve you for a long time without defects.
If this system is operated in any other way, than the one described in this manual, the product may suffer
damages and the
warranty becomes void.
Any other operation may lead to dangers like short-circuit, burns, electric shock, etc.
You endanger your own safety and the safety of others!
Improper installation can cause serious damage to people and property !