DAPAudio DS-TT-750-USB Скачать руководство пользователя страница 11

Страница: 11 / 17

Adjustment of horizontal “zero” balance and stylus pressure:

   (a) Remove the stylus protector from the headshell, do not touch the stylus tip during the adjustment.
   (b) Set the cueing lever to the lowered position.
   (c) Release the tonearm clamp and lift the tonearm from the armrest to free it.
   (d) Rotate the counterweight, until the tonearm is approximately balanced horizontally (floats freely).
   (e) Refasten the tonearm with the tonearm clamp.
   (f) Hold the counterweight stationary with one hand and rotate only the stylus-pressure ring, to bring
   The number “0” of the ring into alignment with the center line on the tonearm rear shaft.
   (g) Rotate the counterweight including the stylus-pressure ring counterclockwise, until the scale shows
   the value, corresponding to the pressure of the stylus used. Now fix the stylus using the fixing screw.
New cartridges will tell what the ideal number is. As a rule of thumb, however, most "hi

‐

fi" cartridges

track between1 and 2 grams, while most DJ cartridges track between 3 and 5 grams. For the
supplied cartridge we suggest 4 grams.
  9. Set the anti-skating control knob to the same value as the stylus pressure. In other words, if the
  tracking force is 2 grams, set the anti

‐

skate dial to "2". The exception is for DJ's

who scratch and back

‐

cue. Your anti

‐

skate must be left on "0"

Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

Install this device on a flat surface.
Cartridge may pick up slight sound pressure or vibrations from the speakers coming along the floor or
though the air resulting in feedback or “howling” sound. Find a location that is very stable and vibration
free.
The legs have functions for adjusting the height of the unit itself. Adjust the legs to stabilize the main body
horizontally.

Do not supply power before

all components of the system are

set up and connected properly.

Connections

1. Connect the power cord to the auxiliary power outlet on the rear panel of your amplifier, receiver or to
  an AC outlet.

2. Connect the unit’s output terminals to the PHONO jack of your amplifier or receiver.
  Output terminals Mixer (Receiver)
  L (White) ---------------------------> L Channel
  R (Red) -----------------------------> R Channel
  GND (Spade) --------------------> Ground

NOTE:

Be sure to connect the ground terminals firmly to the mixer or receiver. Otherwise hum could be

created.

Operation

Phono Playback

1. Turn on the power with the

Power Switch (34)

. The speed indicator and the target light will light up.

2. Place a record on the slip mat. When playing a 45-rpm record with a large center hole, place the

45-

rpm adapter

(29)