DAPAudio DS-CDJ-250 MKII, Руководство по эксплуатации продукта

Страница: 13 / 20

11
40. Fader Start Relay:
The Fader Start Relay function allows you to start CD playback simply by moving the Crossfader
to a side.
Front Functions
41. CD 1 Disc Holder
Place the disc in the holder. Press the Eject button to open and close the disc holder.
42. Microphone
¼” unbalanced microphone input.
43. Headphone
You can connect a pair of headphones with a minimum impedance of 32 Ohm to this stereo 1 /4”
jack should be wired as Tip=left, Ring=right and sleeve=ground.
44. CD 2 Disc Holder
Place the disc in the holder. Press the Eject button to open and close the disc holder.
Back Functions
45.
Mains Cord
Check the 115V/ 230V selector before connecting to the mains.
46. Fuse T1A 250V
Replace the fuse only by a fuse of the same type.
47. Power ON/OFF
This is the main Power switch. Press to turn the device on.
48. 115V/230V Selector
Before plugging the DS-CDJ-250 into any wall socket, make sure that the 115V/230V Selector is set
to the proper voltage.
49. Headphone
You can connect a pair of headphones with a minimum impedance of 32 Ohm to this stereo 1 /4”
jack should be wired as Tip=left, Ring=right and sleeve=ground.
50. Master Balanced Out L/R
Use these outputs to connect an amplifier with balanced inputs.
51. Record RCA Unbalanced Out
Use these to connect a recording device .
52. Master RCA Unbalanced Out
Use these outputs to connect an amplifier with unbalanced inputs.
53. Channel 2 Level Selector
This part is the air entrance. Don't obstruct it.
54. Channel 2 RCA Input
Use to connect either a Line level or Phono level device.
55. Channel 1 RCA input
See 55.
56. Channel 1 Level Selector
See 53.
57. GND
Use to connect the ground wire of your turntable.
58. Microphone XLR Balanced Input
XLR balanced microphone input.
59. Microphone Jack Unbalanced Input
¼” unbalanced microphone input.
60. Air entrance
This part is the air entrance. Don't obstruct it.