DAPAudio DCP-26, Руководство пользователя

Страница: 27 / 36

26
DCP-26
Productcode: D2084
Mute
Clicking the mute button allows you to mute the corresponding channel.
Limiter
You can change the limiter settings by typing the value directly into the boxes
Or by setting the knobs using your mouse.
Threshold range: -48dB to +12dB.
Release time: 10 to 100 dB/s
IMPORTANT!
Enabling the limiter on a specific output also changes the way in which the level is displayed on the
corresponding LED VU meter: The level shown on this meter is no longer the “absolute” output level, but
the level of the signal compared to the limiter’s threshold (0 dB point), no matter what the threshold value
is.
PEQ
Both input channels have up to ten parametric EQ’s. Each parametric equalizer can be configured as an
Allpass, Bell, High shelving, Low shelving or a Notch filter.
Select the filter type using the roll down menu.
Adjust the gain, frequency and Q factor by typing the value in the box.
The gain and frequency can also be adjusted by clicking and dragging the EQ points in the display.
Range frequency: 20Hz to 20kHz
Range Q factor: 0,20 to 25
Range gain: -12dB to +12dB
Switch the filter on or off by clicking the On button.
High Pass Filter and Low Pass Filter
Each input has a Lowpass and a Highpass filter which can be configured as a: But(terworth) 6dB,
Bes(sel)6dB, But(terworth) 12dB, Bes(sel) 12dB, L(inkwitz) R(iley)12dB, But(terworth) 18dB, Bes(sel) 18dB,
But(terworth), 24dB and Bes(sel) 24dB
Select the filter type using the roll down menu.
Adjust the frequency by typing the value in the box. The LPF and HPF can be switched off by typing “
off ”
in the value box.
C. In B menu
See B: In A menu.