24
PSS-106 Battery Speaker
Product code: D2612/D2613
Bluetooth Mode
Attention
Bluetooth can be used only for receiving of wireless audio signals.
Bluetooth can only be used as a means to receive wireless audio signals. It is not possible to pair the
device with other devices via Bluetooth.
For this control mode to work, you need to pair your mobile device and the receiver via Bluetooth.
See 5.6. Pairing Mobile Devices with the Receiver via Bluetooth on page 18 for more information. Press the
MODE button (36) until the display (35) shows BT.
●
Repeatedly press the FORWARD/ and BACKWARD/VOLUME – (37/39) buttons to select
tracks backward/forward.
●
Press and hold down the FORWARD/ and BACKWARD/VOLUME – (37/39) buttons to
decrease/increase the volume. The adjustment range is 0–27, from low to high volume.
●
Press the PLAY/PAUSE button (38) to play the currently selected track. Press the button again to
pause the playback.
Note: When your mobile device receives an incoming call, press the PLAY/PAUSE button (38) to answer
the call. When the conversation is finished, press the button again to end the call and return to Bluetooth
mode.
7.
Troubleshooting
This troubleshooting guide contains solutions to problems which can be carried out by an ordinary
person. The device does not contain user-serviceable parts.
Unauthorized modifications to the device will render the warranty void. Such modifications may result in
injuries and material damage.
Refer servicing to instructed or skilled persons. Contact your Highlite International dealer in case the
solution is not described in the table.
Problem
Probable cause(s)
Solution
The device does not
function at all
No power to the device
●
Check if the device is switched on
●
Make sure the batteries are inserted
properly into the wireless microphone
●
Replace the batteries with new ones
The battery is depleted
●
Recharge the battery. See 4.5. Charging
the Battery on page 15
No sound
Devices are not paired
●
Check if the device and external
devices are paired
Bad connections
●
Check if the connections between the
device and external devices are correct
Bursts of noise or
other audible signals
present
Sources of interference are present
●
Identify potential sources of interference
(other RF-sources) and turn them off
Momentary loss of
sound as the device
is moved around
performing area
Dead spots are present
●
Reposition the device and perform a
walk-through test again. If audible drop-
outs persist, mark the dead spots and
avoid them during performance
Содержание D2612
Страница 28: ...2022 DAP...
