DAPAudio D2250, Руководство пользователя

Страница: 6 / 43

10 20 50 100 200 500 1K 2K 5K 10K 20K 50K
+20
+15
+10
+5
+0
-5
-10
-15
-20
+20
+15
+10
+5
+0
-5
-10
-15
-20
10 20 50 100 200 500 1 2K 5K 10K 20K 50K
+20
+15
+10
+5
+0
-5
-10
-15
-20
10 20 50 100 200 500 1K 2K 5K 10K 20K 50K
1)HIGH:12KHz ± 15dB shelving type
LOW:80Hz, ± 15dB shelving type
2)HI-MID:800Hz-8KHz(variable)
± 15dB peaking type
3)LOW-MID:160Hz-1.6KHz
(variable),
± 15dB peaking type
7. 4BAND EQ CONTROLS(HIGH, HI-MID ,
LOW-MID, LOW)
This is a 4 - band equalizer with center frequencies, range, and
type as shown below. The frequency response is flat when the
knob is in the center position.
8. AUX 1~8 CONTROLS
This knobs control the level of the signals sent to AUX buses.
- The AUX 1 ~ AUX 4 controls are pre-fader, and the signal
levels sent to the AUX 1~AUX 4 buses will be unaffected by the
channel fader setting .
- The AUX 5 / AUX 7 and AUX 6 / AUX 8 controls will be
affected by the POST/PRE SELECT SWITCH and SHIFT 7/8
SIGNAL SELECT SWITCH setting.
9. AUX 5~8 POST/PRE SELECT SWITCH
-
POST( ,RELEASAED SWITCH):
Selects the post-fader signal from the point in the channel after
the MUTE OFF switch. Because the signal feeding this position
will be subject to any adjustments to that channels inputs fader,
this position is usually preferred for effects or echo mixes.
- Pre( ,DEPRESSED SWITCH):
Pre-Fader signal is taken from the stage preceding the fader EQ,
so it is not affected by the channel's fader.
10. AUX 5~8 SIGNAL SELECT SWITCH(SHIFT)
This SHIFT 7/8 SWITCH connects the two level controls ( as a
pair) to either AUX 5 ＆ 6 sends or to AUX 7 ＆ 8 sends.
When this switch turns on, the AUX signal will be shifted from
AUX 5/AUX 6 to AUX 7/AUX 8.
In this case ,you can adjust AUX 7 / AUX 8 signal with AUX5/
AUX 6 controls.
8 BUS MIXING CONSOLE
5