DAPAudio COM-31 Guitarist, Руководство пользователя

Страница: 8 / 17

Installation
Remove all packing materials from the Com-31. Check that all foam and plastic padding is removed.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
1. Refer to Figure 4. Connect the supplied power AC adapter into the DC input Connector (16) at
the back of the receiver. Plug the afdapter in a wall socket or other AC power source. Push the
POWER switch (1) on the front of the receiver, the red power LED will light.
2. Insert the supplied antennas in the antenna sockets (6,7) and rotate fully clockwise. Position the
antennas at an angle of 45 degrees.
3. Connect your guitar receiver’s ¼” jack output connector (10) to your amplifiers input using a
standard guitar cable.
4. Connect your guitar or bass to the transmitter input jack (16) with an instrument adapter and
rotate the ring to lock the connector.
5. Adjust the volume control of your guitar to the desired level. To mach the wirless to that of a wired
system, see the section ReceiverVolme adjustement for the guitarist UHF on page 7.
6. Slide the recessed transmitter POWER/OFF switch (12) to the power position. The indicator will light
for a moment and the receivers A/B LED’s (3) will light.
7. If the performance is over, turn off the sound system and slide the transmitter’s POWER/OFF switch
(12) to the off position to conserve battery power.
Front Back
Fig. 4
6