DanVex AD-550, Руководство по эксплуатации

Страница: 8 / 12

R
www.danvex.fi 7
Pic. 2. AD- 55 0 dehumidifier dimensions
Installation
Installation and the covered area
AD -550 dehumidifier is designed for indoor installation. It should be positioned upright on an
even surface. It is recommended to fix the dehumidifier. It is required to leave some free space
(1000 mm) in front and above the dehumidifier for filters, fans and rotor maintenance and
inspection.
Channel connections for permanent installation
The dehumidifier can be installed directly in the room to be dehumidified or in a separate
ventilation chamber. In case of special versions it can be places outdoors as well. To assure
better parameters and efficiency the air outlets should be equipped with diffusers.
Moist air duct
Moist air should be discharged outside the dehumidified loop (to outdoors) . The air duct
should be as short as possible to minimize the possibility of condensation of the moisture
from the moist air. The duct should be slightly inclined downwards to prevent the condensate
entering the equipment. In case it is required to install the moist air duct upright it should be
insulated and drain holes should be drilled in the lowest part of the elbow bend
(2-4 mm ).
Regeneration air duct
The regeneration air duct should be as short as possible. A metal net is installed at the duct input
to prevent foreign matters entering the dehumidifier. There is no need to insulate the duct. The
duct inclination angle is
optional .
Dehumidified and dry air ducts at the dehumidifier installation inside the dehumidified
loop
As a rule in case the dehumidifier is installed in the dehumidified loop air ducts for the air intake
are not required. A dry air duct is connected with the air-ducting system for dry air distribution
inside the premises.
Dehumidified and dry air ducts at the dehumidifier installation outside the dehumidified
loop
In case the dehumidifier is installed outside the dehumidified loop either a recirculation or an
open circuit is used. If a recirculation circuit is used the air to be dehumidified is supplied from the
loop via an air duct and the dehumidified dry air is supplied to the dehumidified room the same
way. If an open dehumidification circuit is used only dry air is supplied to the room.
Electrical connection
Please see the attached electric diagram