Dantherm WA 45, Руководство по обслуживанию

Страница: 12 / 71

- 11 -
970006_SM_WA 45-300_4.3_EN-TY-FR_20100922.doc
¾ Draw out the turbulators through the upper heat exchanger pipe (1).
¾ If there is no visible dirt in the heat exchanger, the unit is reassembled as described above, but
in reverse order. Always use new sealing rings when reassembling the unit.
¾ If it is necessary to clean the heat exchanger, remove the service cover (3) above the burner
and check the combustion chamber (4) for dirt.
¾ Then clean each heat exchanger pipe (1) and (7) by a round wire brush. Remove the
inspection door into the flue gas collector (6) and take out the soot through the opening in the
collector by a vacuum cleaner.
¾ The soot from the lower heat exchanger pipes is taken out through the combustion chamber
(4) by a vacuum cleaner.
¾ Then clean the turbulators and push them back into the upper front heat exchanger pipes (1)
and (7) and reassemble the unit in the reverse order.
4.3 Fan and V-belt
In order to check fan and V-belt remove the service door in the unit front. The condition and the
adjustment of the V-belt must be checked. The fan runner should be checked for dirt every 6
months and tightened up if necessary.
4.4 Other components
All other components in the WA 45 - 300 units are service-free. The burner should be checked
according to the instructions of the burner supplier. The function of all internal thermostats must be
checked once a year.
5. FAULT FINDING
In case of failure, check the following:
¾ Is there any gas at the burner?
¾ Is there any oil in the tank and are all valves open?
¾ Is the power supply to the unit OK?
¾ Is the room thermostat/seven days programme panel setting higher than the room
temperature?
¾ Are the air intake and air outlet openings free?
If the above points are OK, check the heater according to the table below.