Dantherm HRC 2, Руководство пользователя

Страница: 9 / 28

9
065379
•
V
er
si
on
1
.1
•
06.
03.
201
3
Night mode
In Night mode the unit runs at fan step 1, and this mode functions togeth-
er with Auto, Manual or Week program mode.
Start and end time for night mode are set in the following way:
Night mode is deactivated by pressing CENTER, while the icon is flashing.
Step Action
1 When night mode is activated (symbol flashes) press DOWN and
the start time is shown in the info line (flashes).
2 Set start time by pressing UP/DOWN, confirm by pressing CEN-
TER, and then the end time is shown in the info line.
3 Set the end time by pressing UP/DOWN, confirm by pressing
CENTER. The start and stop time for night mode are now set.
Afterheating
If afterheating is connected (accessory) it can be adjusted in accordance
with one or more of the following 3 principles:
T2) Afterheating for comfort supply air:
If afterheating is only required to prevent supply of cold air or draught in-
convenience, the T2 supply air temperature can be used as setpoint and
regulation temperature. (Factory s18°C)
T3) Afterheating for heating of the house:
If afterheating is used as primary heat source for the whole house, T3 ex-
tract air temperature can be used as setpoint and regulation temperature.
(Factory setting = OF, meaning that heating is not regulated after this set-
point)
T5) Afterheating for heating of the house or rooms:
If afterheating is used as primary heat source for the whole house and/or
specific rooms, T5 temperature measured in the remote control can be
used as regulating temperature in the room where it is placed. (More re-
mote controls can be connected) (Factory setting = OF, meaning that heat-
ing is not regulated after this setpoint)
NB: If all three afterheater setpoints are “OF” the afterheater is OFF.
(T3/SET)
(T5/SET)
(T2/SET)
afterheater icon