Dantherm HCV 3, Руководство пользователя

Страница: 39 / 88

37
060
79
3 •
V
ersi
on
1.
2 •
26
.04
.2
011
Fault finding guide
Alarms Localise the problem in the left column and follow the instructions in the right column
Alarm Cause Action
Yellow light-emitting diode
(30/min) and a beep-
sound. The filters need to be
checked/changed. Change the filters and re-
set the filter timer on the
unit. See the section
”Preventive maintenance”,
on page 33.
Red, permanent light-
emitting diode and beep-
sound.
Red, flashing light-emitting
diode (30/min) and beep-
sound.
The unit has an electrical
malfunction. Take contact to your elec-
trician.
Red, flashing light-emitting
diode (120/min) and beep-
sound. High or low temperatures
have been detected inside
the unit. Disconnect the power
supply of the unit. Make
sure that there is no
smoke or fire in the house.
Contact your installer.
If the unit is not operating
due to low temperatures,
start up the unit in Installa-
tion Mode, see the section
“User’s guide” on page 12.
Malfunction Localise the problem in the left column and follow the instructions in the right column
Malfunction Cause Action
The unit does not operate,
and there is no light on the
control panel. Power is not connected. Make sure that the power
supply cable is mounted
correctly.
There is water
around/beneath the unit. The unit is not installed
correctly. The unit might
be leaking while it is oper-
ating due to a clogged
drain. Check and clean the
drainage hose. Mount it
again according to the in-
structions in the installa-
tion manual. If that does
not help you must contact
your installer.
Continued overleaf