Dantherm BasX, Руководство по обслуживанию

Страница: 7 / 33

7
039073 • V
ers
ion
1.
0 • 05
.03.
2007
Scheduling service inspections, overview
Introduction This section gives an overview of the parts to be regularly serviced.
Read more in each section of each part about what kind of service is necessary and
how to carry out this service inspection.
Categories
Dantherm Air Handling has categorized the service inspections to be carried out:
•
Four times a year
•
Every 5000 operating hours or at least once a year
• Once a year
•
When the catalogue value for recommended end pressure loss is exceeded
Four times a year Check the following parts at least four times a year to ensure optimal operating
performance:
Component Service Reference
Rotary heat
exchanger Check and tighten the belt-drive Page 15
Fan Check and tighten the pulley Page 11
Once a year Check the following parts at least once a year to ensure optimal operating performance:
Component Service Reference
Cabinet Clean the cabinet
Check the seals and closing mechanisms Page 10
Damper Check the air-tightness Page 22
Rotary heat
exchanger Check the condition of the rotor and that it turns
easily
Check the brush seals
Check the drive system Page 15
Cross-flow heat
exchanger Check the heat exchanger
Check the air-tightness of the bypass damper
Lubricate the movable parts of the bars
connected to the damper motor
Clean the drip tray, drain and water trap Page 13
Run-around heat
exchanger Check the condition of the coils
Vent the coils
Clean the drip tray, drain and water trap (exhaust
air)
Check the droplet eliminator (exhaust air)
Check the pump Page 17
Heating coil Check the condition of the coil
Vent the water coil Page 20
Continued overleaf