P
AGE
2
46310-IG-0300 <90-00226>
INTRODUCTION
T
his Installation Guide is presented as an aide to assist in the
installation of the 46310-0X TL1 PointMaster. It is not
intended as a stand-alone document, but rather requires the
installer to have either the full PointMaster practice or a good
working knowledge of the product.
For the purpose of this Quick Installation Guide, it is assumed
that the PointMaster is to operate as TL1 on the Master Port
and Printer on the Craft Port.
INSTALLATION
A
s you proceed with steps 1 and 2, verify that the proper
cards are inserted in the Dantel PointMaster and are
installed in the right slots. Verify the correct version of the TL1
PointMaster Editor software and that the proper interface cable
is on-site.
If the TL1 Editor is already loaded on your computer, skip
Section 1 and begin at Section 2.
S
ECTION
1 - L
OAD
TL1 P
OINT
M
ASTER
E
DITOR
For this section, refer to the TL1 Editor section of the TL1
PointMaster practice.
1.
Open Windows.
2.
Insert the PointMaster software disc into the floppy drive (A:).
3.
Click the “Start” button.
4.
Click the “Run” button.
5.
In the command line, type: A:\setup.exe. Click OK.
6.
At the welcome screen, click Next (at the bottom).
7.
At the User Info screen, enter any optional information desired.
Click Next (at the bottom).
8.
At the Choose Destination Location screen, confirm the path:
C:\program files\Dantel\PointMaster. Click Next.
9.
At Start Copying Files, click Next.
10.
Wait until the Setup Complete screen comes up. Click the Yes but-
ton to launch the program.
11.
Click Finished.
12.
Minimize the screen for later use.
13.
End of section 1. Continue on to section 2.
