unDNEMO
User Manual
Attero Tech LLC 2016
Page 13
614-00030 Rev 02
3.3 – Dante Configuration Notes
In general, there is little to no additional configuration required to successfully utilize the unDNEMO devices in a Dante
network other than the initial channel configuration and setup required using the unIFY Control Panel software.
However, if the unDNEMO is utilized in a Dante network with audio transmit channels that are already configured to
transmit to one or more Dante receive devices, the potential exists that the unDNEMO will not be able to subscribe to the
Dante transmitter as the number of unicast receivers assigned to transmitting device and channel may be exceeded.
To mitigate this issue, the desired audio channels may be placed in multicast flows such that there is no limit on the
number of Dante receive devices. In systems where a large number of unDNEMO devices are utilized, this is the
recommended practice to mitigate these channel subscription limitations that exist when only using unicast Dante audio
transmission. Care should always be taken to understand how much multicast bandwidth exists on the Dante network,
and utilize the tools within Dante Controller to identify any networking and Dante configuration issues.
