15
key-press to leave the edit state. The operation under the edit state please
refers to the back.
2.6.6
RUN PATROL
：
Run patrol function. Use PAN LEFT/PAN RIGHT to
choose paths number, push OPEN key-press to run and exit.
2.6.7
RECORD PATTERN
：
Edit tracking self-inspection, may remember at most
40 seconds PTZ operation. The 40 seconds is up or push CLOSE key-press to
finish edit.
2.6.8
RUN PATTERN
：
Run tracking self-inspection. After it is run, User will
leave the menu. The control of the joystick may stop its running.
2.6.9
RETURN
：
Return to the main menu.
3
．
Menu Appendix
3.1
Patrol tracking parameter edit.
After User enters the edit state, the
screen will display as follows:
NO
：
tracking point number
POS
：
preset points number
TM
：
the staying time at this pre-setting
point
SEQ
：
01 displays the current setup is 1
CLOSE:EXIT
：
push CLOSE to exit
The top line and bottom line show the indicating information, the middle shows
every tracking paths information. Every line shows 2 tracking points parameter.
Use PAN LEFT/RIGHT to move cursor, use TILT UP/DOWN may amend the
number.
Push CLOSE key-press to leave the edit state and save the
amendment. The program will search the first POS with the position of “---”, and
will save the former data and the latter data is of no effect. As the picture above,
the program saves the four tracking points. The scope of POS is 1-128. When
POS is “---”, it means that the tracking scope is end. TM’s scope is from 0 to 99
seconds.
