19
Chapter 5 OPERATION
5.1. Configure after power on
After connect all wirings as the instruction and turn on the power, the camera will display its configured information.
And after it finish configure, the menu will show “configure OK” information. If the user sets the POWER UP DONE,
the camera will execute this movement and the tips information disappear; if the user does not set the POWER UP
DONE, the tips information will be kept until the camera receive the control command, then the tips information will
disappear and show the system communication control is normal. If the camera does not receive the control
command, the tip information will disappear automatically after 3 minutes.
Power up display:
：
When configuring
：
Configure OK:
：
NOTE:
1. VERSION 1.2 is the software version number of the camera, and it will change as the product’s upgrade.
2. PROTOCOL P is control agreement, can support P, D protocol, and it will change as the dip switch chooses
different protocol.
3. ADDRESS 1 is control address, can support 256 addresses, and it will change as the dip switch chooses
different protocol.
4. COMM 2400.N.8.1 is communication information, 2400 is communication baud rate, there are 1200, 2400,
4800, 9600 four baud rate for different dip switch. N.8.1 means no verify, 8 data byte, 1 dwell position.
After the dome finish configure, you can operate the camera as the following way:
PAN/TILT CAMERA
VERSION 1.2
PROTOCOL P
ADDRESS 1
COMM 2400.N.8.1
POWER UP DONE
PAN/TILT CAMERA
VERSION 1.2
PROTOCOL P
ADDRESS 1
COMM 2400. N.8.1
CONFIGURING
PAN/TILT CAMERA
VERSION 1.2
PROTOCOL P
ADDRESS 1
COMM 2400. N.8.1
CONFIGURE OK P:000/T:000