Dansons Group Home Heater HGBH1, Руководство пользователя

Страница: 22 / 40

22
O
O
PERATING
PERATING
I
I
NSTRUCTIONS
NSTRUCTIONS
FILL THE HOPPER WITH FUEL:
Open the hopper lid by placing your fingers in the recessed
handle on the hopper lid and lifting upward.
Lift the lid until the lid is fully open, toward the back of the
stove, and stays open by itself.
Ensure the hopper is clean of any debris, MANUALS, or
other foreign objects that could jam up the fuel feed auger.
You may wish to wipe clean any oils, or manufacturing
leftovers, using any cleaning agent and a cloth. As well
a light application of car wax to the hopper will aid in
reducing build-up of dust and fines within the hopper.l
Be careful not to spill any fuel on the top of the stove and
adjoining gaps. Spilling fuel on the floor can also pose a
slipping hazard.
CLOSE THE LID, place finger into the recessed handle and
With control, pull the lid toward the front of the stove.
CAUTION: WATCH YOUR FINGERS.
Basic Overview
The AcuTron digital control board with Memory was designed to give you flexibility
on how you want to operate your stove. The AcuTron can be operated as a
MANUAL control or by a THERMOSTAT. When operating in the Thermostat
option, you can also choose to run your appliance in the ON/OFF mode or the
LOW/HIGH mode.
The START or FEED RATE touch pad allows electricity to flow to your stove's
electrical components for 15 minutes. If after 15 minutes your stove has heated to
normal operating temperatures your stove will continue to run. If the fire does not
light and/or burn properly, the electricity to your stove's components will be shut off
at the end of 15 minutes.
The FAN SPEED controls the speed of the room air fan. This fan blows room air
through the heat exchange tubes and back into the room. When the FEED RATE
is set to a higher position, the FAN SPEED should be set higher and visa versa.
To achieve optimum heat transfer it is recommended to set the FAN SPEED to
LOW or LOW/MED when running the FEED RATE at 1 or 2, and Fan on MED OR
MED/HIGH on FEED RATE #3 or 4.
When the START / FEED RATE is ON , the AUGER CYCLE LED will turn on when
the auger is active. When the OFF touch pad is pushed [OFF], the auger motor will
not run, fuel stops feeding and the fire will die.
The FEED RATE works in a synchronized manner setting both the fuel rate and combustion air at the same time. When
fuel is increased by setting the FEED RATE higher, combustion air is automatically increased and visa versa.
MEMORY — If a power outage occurs, the board will remember the function it was performing and return to that function
when the power returns.
MODE OF OPERATION SELECTION - All 3 modes of running the control are now activated by using the OFF button to
program. (More detail to follow in this section)
FAN TRIM —Allows for fine tuning of the exhaust fan, at the Lower (#1) Feed Rate. This aids in adjusting for fuel, eleva-
tion, venting and heating requirements.
Glow Boy Home & Shop Heater www.glowboystoves.com 22
as desired as desired
Memory &
Fan Trim
II or IIIw/Memory& FanTrim