Dannmar T-100, Инструкция по установке и эксплуатации

Страница: 12 / 56

9. Place tire/wheel assembly on table top with mounting
side up (See Fig. 1)
10. Use the clamp control pedal to move the clamps inward
(pedal down) or outward (pedal up). (See Fig. 2.)
11. Apply tire manufacturer’s approved rubber lubricant
liberally to entire circumference of both beads after loosening
bead and placing on table top. Using the mount/demount
roller to hold down the top bead while rotating the turntable
will make lubrication easier. (See Fig. 3)
12. Use the lower bead helpers to assist in the bottom bead
lubrication. (See Fig. 4)
13. After the wheel is secured to the turntable, pull the over-
head swing arm into position so that the mount/demount
head is directly over the edge of the rim. Push down on the
vertical slide until the mount/demount head comes in con-
tact with the edge of the rim. . ( See Fig. 5 )
14. Push the vertical slide down and position the demount
head into contact with the rim edge. (See Fig. 6-7)
15 .Push up on the locking handle to lock the slide into
position. As the slide is locked, the mount/demount head
will move upward approximately 1/8 inch and backward 1/8
inch from the rim edge. The mount/demount head roller
should not be in contact with the rim edge. (See Fig. 1)
12
NOTE
Clamp steel wheels from the inside (clamps
push outward against wheel). Clamp mag and
custom wheels from the outside (Clamps push
inward against the outside rim edge). Refer to
the Performance Tires and Wheels section.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 7
Fig. 5
Fig. 6
Fig. 1