Dannmar DB-70, Инструкция по установке и эксплуатации

Страница: 10 / 68

DB-70 Automatic Wheel Balancer
10
P/N 5900261 — Rev. A1 — January 2021
Installation Checklist
Following are the steps needed to install the Wheel Balancing Machine. Perform them in the order
shown.
☐
1. Unpack and verify that all parts are accounted for and undamaged.
☐
2. Review the installation Safety Rules.
☐
3. Verify that there is a power source available at the installation location. Make arrangements for an
electrician, if required.
☐
4. Make sure you have the necessary Tools.
☐
5. Make sure there is adequate clearance around and above the DB-70.
☐
6. Unpack the Components.
☐
7. Connect the matcher to the Balancer shaft.
☐
8. Install the tray and control panel.
☐
9. Move the unit to its permanent Location.
☐
10. Anchor the Unit.
☐
11. Install the Tire Cover.
☐
12. Connect to Power. This will require a
licensed Electrician
if you are converting to 220 VAC.
☐
13. Test the Balancer. See Balancer Testing.