Assembly
& Operating
Instructions
The following instructions will assist you in assembling
,
operating and maintaining
your
fountain. Depending on which fountain you have purchased
,
there
may
be slight variations in how
they get assembled.
Santa Fe - Item # 03880
STEP 1
STEP 2
STEP
5
STEP
4
STEP
7
STEP
8
HELPFUL
TIP
S
:
STEP
6
STEP 3
Fig. A
Fig. B
Fig. C
Fig. D
Fig. E
1)
If water does not flow shortly after power up, unplug and refer to STEP 1 to confirm
that the flow control is in the fully open position.
OR
Air may be trapped within the
pump. Remedy this by removing the pump & placing back into the filled basin.
2)
If splashing occurs when the fountain is running, try reducing the flow rate of the
pump by sliding the stem on the front cover towards the minus
(-)
side.
(
see Fig. B
)
SET THE "FLOW CONTROL" ON THE PUMP TO THE FULLY OPEN POSITION. DO THIS BY SLIDING THE
STEM ON THE FRONT OF THE PUMP COVER ALL THE WAY OVER TO THE "+" SIGN.
(Fig
.
B
)
.
ATTACH THE INCLUDED PLASTIC FITTING INTO THE PUMP OUTLET (
Fig
. B
)
(DEPENDING ON YOUR
MODEL, SOME FITTINGS MAY ALREADY BE PRE-INSTALLED AT THE FACTORY)
LOCATE AND PULL
THE
OPEN END OF THE
PLASTIC FILL TUBE
OUT
FROM THE OPENING IN THE REAR
OF THE FOUNTAIN AND PUSH IT ALL THE WAY DOWN ONTO THE PUMP FITTING.
(Fig.
C
)
ATTACH
THE POWER CORD PLUG COMING FROM THE PUMP TO THE
SOCKET ON
THE A.C.
ADAPTER. PUSH IT ALL THE WAY IN THEN SECURE THE CONNECTION BY SCREWING THE NUT ONTO
THE THREADED NECK UNTIL TIGHT
.
(Fig
.
D
)
ATTACH
THE
L.E.D.
BARREL CONNECTOR COMING OUT OF THE FOUNTAIN
OPENING
TO THE
MATING SOCKET ON THE WIRE LEAD COMING FROM THE PUMP.
PUSH IT ALL THE WAY IN
THEN
SECURE THE CONNECTION BY SCREWING THE NUT ONTO THE THREADED NECK UNTIL TIGHT.
(Fig
.
E
)
PLACE THE PUMP INTO THE OPENING IN THE REAR OF THE FOUNTAIN, MAKING SURE THAT THE
BARREL CONNECTOR (
Fig.
E
) REMAINS OUTSIDE OF THE FOUNTAIN. (THIS CONNECTION
MUST
REMAIN OUT OF THE WATER
AS SHOWN IN
Fig
.
F
)
.
FILL THE FOUNTAIN WITH WATER.
MINIMUM
WATER LEVEL REQUIRES THE PUMP TO BE
COMPLETELY SUBMERSED.
MAXIMUM
LEVEL IS JUST BELOW THE LOWER EDGE OF THE
OPENING .
PLUG A.C. ADAPTER INTO GFCI OUTLET. BE SURE TO LEAVE A "DRIP LOOP" IN THE WIRE.
(SEE FIG. 1
ON NEXT PAGE)
F
itting
Solace
- Item # 038
82
Eternity- Item # 03881
Fig. F
IMPORTANT
:
BEFORE PROCEEDING TO STEPS 4 & 5 MAKE SURE THE CONNECTORS FOR THE PUMP AND L.E.D. LIGHTS HAVE
"O"RINGS
INSTALLED ON THEM (SEE FIG. A)
"O" Ring
