P
I
02 9604 1226 E
I
|
danielaappliances.com.au
PA G E 1 1
P
I
02 9604 1226 E
I
|
danielaappliances.com.au
PA G E 1 0
TURNTABLE INSTALLATION
A) Control panel
B) Turntable shaft
C) Turntable ring assembly
D) Glass tray
E) Observation window
F) Door assembly
G) Safety interlock system
Materials to be avoided in microwave oven
Utensils Remarks
Aluminum tray
Food carton with
metal handle
Metal or metal-
trimmed utensils
Metal twist ties
Paper bags
Plastic foam
Wood
F
G
A
C
B
E
D
SETTING UP YOUR OVEN
Names of Oven Parts and Accessories
Remove the oven and all materials from the carton and oven cavity.
Your oven comes with the following accessories:
Glass tray 1
Turntable ring assembly 1
Instruction Manual 1
Metal shields the food from microwave energy. Metal trim may
cause arcing.
May cause a fire in the oven.
Plastic foam may melt or contaminate the liquid inside when exposed
to high temperature.
Wood will dry out when used in the microwave oven and may split
or crack.
May cause arcing. Transfer food into microwave-safe dish.
May cause arcing. Transfer food into microwave-safe dish.
May cause arcing and could cause a fire in the oven.
Grill Rack( Only be used in grill function
and be placed on the glass tray )
7
TURNTABLE INSTALLATION
a. Never place the glass tray upside down. The glass
tray should never be restricted.
b. Both glass tray and turntable ring assembly must
always be used during cooking.
c. All food and containers of food are always placed
on the glass tray for cooking.
d. If glass tray or turntable ring assembly cracks or
breaks, contact your nearest authorized service
center.
Hub (underside)
Glass tray
Turntable ring assembly
Turntable shaft
The accessible surface
may be hot during
operation.
Installation and connection
1.This appliance is only intended for domestic use.
2.This oven is intended for built-in use only.It is not intended for counter-top use or for
use inside a cupboard.
3. Please observe the special installation instructions.
4.The appliance can be installed in a 60cm wide wall-mounted cupboard(at lease 55cm
deep and 85cm off the floor).
5.The appliance is fitted with a plug and must only be connected to a properly installed
earthed socket.
6.The mains voltage must correspond to the voltage specified on the rating plate.
7.The socket must be installed and connecting cable must only be replaced by a
qualified electrician.If the plug is no longer to accessible following installation,an
all-pole disconnecting device must be present on the installation side with a contact
gap of at lease 3mm.
8.Adapters,multi-way strips and extension leads must not be used. Overloading can
result in a risk of fire.
8
a.
Never place the glass tray upside
down. The glass tray should never
be restricted.
b.
Both glass tray and turntable ring
assembly must always be used
during cooking.
c.
All food and containers of food are
always placed on the glass tray
for cooking.
d.
If glass tray or turntable ring assembly
cracks or breaks, contact your nearest
authorized service centre.
SETTING UP YOUR OVEN
Remove the oven and all materials from the carton and oven cavity.
Your oven comes with the following accessories:
•
1 x Glass tray
•
1 x Turntable ring assembly
•
1 x Instruction Manual
INSTALLATION AND CONNECTION
1.
This appliance is only intended for domestic use.
2.
This oven is intended for built-in use only. It is not intended for counter-top use or for use
inside a cupboard.
3.
Please observe the special installation instructions.
4.
The appliance can be installed in a 60cm wide wall-mounted cupboard
(at least 55cm deep and 85cm off the floor).
5.
The appliance is fitted with a plug and must only be connected to a properly installed
earthed socket.
6.
The mains voltage must correspond to the voltage specified on the rating plate.
7.
The socket must be installed and connecting cable must only be replaced by a
qualified electrician.If the plug is no longer to accessible following installation,
an all-pole disconnecting device must be present on the installation side with a
contact gap of at least 3mm.
8.
Adapters, multi-way strips and extension leads must not be used.
Overloading can result in a risk of fire.
INSTALLATION INSTRUCTIONS
The accessible surface may
be hot during operation.
ELECTRICAL CONNECTION
•
The oven is fitted with a plug and must
be only connected to a properly installed
earthed socket. In accordance with the
appropriate regulations, the socket must
only be installed and the connecting
cable must only be replaced by a
qualified electrician.
•
If the plug is no longer accessible
following installation and all-pole isolating
switch must be present on the installation
side with a contact gap of at least 3mm.
Installation Instructions
Please Read the Manual Carefully Before Installation
Please Note
Electrical connection
The oven is fitted with a plug and must be only connected to a properly installed earthed
socket. In accordance with the appropriate regulations, the socket must only be installed and
the connecting cable must only be replaced by a qualified electrician.
If the plug is no longer accessible following installation and all-pole isolating switch must
be present on the installation side with a contact gap of at least 3mm.
TRIM-KIT PLASTIC
COVER
SCREW
9
Installation Instructions
Please Read the Manual Carefully Before Installation
Please Note
Electrical connection
The oven is fitted with a plug and must be only connected to a properly installed earthed
socket. In accordance with the appropriate regulations, the socket must only be installed and
the connecting cable must only be replaced by a qualified electrician.
If the plug is no longer accessible following installation and all-pole isolating switch must
be present on the installation side with a contact gap of at least 3mm.
TRIM-KIT PLASTIC
COVER
SCREW
9
