P
I
02 9604 1226 E
I
|
danielaappliances.com.au
PA G E 1 2
INSTALLATION – GAS CONNECTION
These Technical Instructions have been prepared for use by Authorised persons.
PLEASE RECORD YOU PLUMBERS DETAILS AT THE BACK OF THIS BOOK – INCORRECT
INSTALLATION OF GAS FITTINGS AND APPLIANCES ARE NOT COVERED UNDER WARRANTY!!!
•
This unit must only be installed by an Authorised person e.g. licensed plumber and gasfitter
– FAILURE IN DOING SO WILL RESULT IN ALL WARRANTIES BEING VOIDED.
•
This appliance is for use with connections using rigid copper connection or;
•
This appliance is suitable for installation with a flexible hose connection. Hose connection
must be to AS1869 – Class B; and be no more than 1.5 metres in length. Hose must be
support independent of any surface which may become hot.
•
Gas Inlet fitting is ½” BSP (male) thread.
•
Fit the appliance inlet elbow and sealing washer and tighten, attach the regulator supplied
for Natural Gas (if applicable) as close as possible to inlet of the hotplate.
•
For LPG appliances, the test point adaptor (supplied) must be fitted. The supply connection
is to be accessible with the appliance installed.
NOTE:
It is recommended that an isolating valve
and union be fitted, to enable disconnection for
servicing. These are to be in an accessible location.
Check connections are gas tight with soapy water
or other approved method.
UNDER NO CIRCUMSTANCES ARE YOU TO USE
A NAKED FLAME WHEN CHECKING FOR LEAKS.
Ensure the appliance operating pressure is
adjusted and set according to these instructions
and local authority requirements. When satisfied
that the hotplate is operating correctly, instruct the
customer in its safe operation. Ensure the customer
understands fully by having them operate the
hotplate and all its functions.
