Dangrill 90790, Инструкция по эксплуатации

Страница: 27 / 62

27
NO
SE
FI
GB
DE
DK
PL
ET
WARNING! Keep children and pets at a safe
distance from the barbecue.
Position the gas hose so that it does not
come into contact with hot parts of the
barbecue and keep it straight.
Only use gas hoses approved by the
relevant national authorities. The gas hose
must be a maximum of 150 cm long and
must be fi tted with an approved regulator.
Check regularly that the gas hose is not split
or crumbling and replace if necessary.
The gas bottle must be placed next to the
barbecue. It must not stand within the
actual barbecue.
The gas bottle must be changed outside at
a safe distance from naked fl ames and other
sources of ignition.
If you discover a leak, turn off the gas supply
at the regulator immediately and avoid
naked fl ames and other sources of ignition.
Wait a few minutes until the area has aired.
Carry out a leak test when you connect a
new gas bottle or if the barbecue has not
been used for a prolonged period. Do not
carry out the leak test using a naked fl ame!
See ‘Leak test’.
Turn off the gas supply using the regulator
after use.
Do not attempt to modify the barbecue,
including the regulator and the burners. Do
not try to open parts that have been sealed
at the factory.
Use barbecue gloves when handling the
barbecue.
Open the lid before you light the barbecue!
If you try to light the barbecue while the lid
is closed, you may cause a gas explosion!
Use separate cooking utensils for raw and
cooked meat. Keep them separate to avoid
transfer of bacteria to the cooked meat and
the risk of food poisoning.
Assembly
Please refer to the illustrations at the back
of the user instructions. It takes 2 people to
assemble the barbecue.
1. Fit one leg (19, 20) to each side panel
(21) with 2 washers (F) and 2 screws (C)
on each.
2. Click 6 brackets (D) securely into the
holes on the underside of the baseplate
(23).
Insert 4 plugs (H) into the holes shown
on the top of the baseplate.
Insert 2 washers (F) and 2 screws (G)
into the holes shown on the top of the
baseplate.
3. Screw the baseplate securely to the 4
legs from below using 2 washers (F) and
2 screws (C) in each corner.
Insert a wheel (24) securely into the
socket on each corner of the baseplate.
4. Turn the frame so that it is standing on
the wheels.