Danfoss VLT ISD Connection Box, Руководство по эксплуатации

Страница: 26 / 58

5 Installation/Fitting
5.1 Transport and Delivery
5.1.1 Scope of Delivery
The scope of delivery of the ISD connection box comprises:
•
the connection box
•
1 set of plug connectors
•
these operating instructions
5.1.2 Transport
The maximum weight of a packaged connection box is
approximately 5.5 kg.
•
Avoid vibration during transportation.
•
Avoid heavy impacts and blows.
5.1.3 Inspection on Receipt
After receiving the delivery, immediately check whether
the scope of delivery matches the shipping documents.
Danfoss will not honour claims for faults registered at a
later time.
Register a complaint immediately:
•
with the carrier in case of visible transport
damage.
•
with the responsible Danfoss representative in
case of visible defects or incomplete delivery.
5.2 Safety Measures during Installation
Always observe the safety instructions in 3 Safety
instructions during installation.
Pay particular attention to ensuring that the following
points are observed carefully:
•
installation may only be performed by qualified
personnel.
•
installation must be performed with due care and
attention.
•
all safety regulations and protective measures are
complied with, and the environmental conditions
are observed.
•
the documentation is read and understood.
5.3 Installation Environment
Environmental Conditions
The installation must provide the following environmental
conditions to allow the connection box to be operated
safely and efficiently.
•
The allowable operating ambient temperature
range is not exceeded.
•
The relative humidity is 5-85%, non-condensing
(according to IEC 60721-3-3).
•
The vibration level is ≤1 g/9.81 m/s
2
without
resonance excitation.
•
Unrestricted ventilation is available.
•
The maximum operating temperature is 40 °C. A
control cabinet climate control should be used if
necessary.
Contact Danfoss if it is not possible to comply with these
environmental conditions.
Installation/Fitting
VLT
®
ISD Connection Box Operating Instructions
24 MG75G102 - VLT
®
is a registered Danfoss trademark
5 5