8 Appendix
8.1 Disclaimer
Danfoss shall have no obligation with respect to any
product that
•
is not installed according to the standard configu-
ration as specified in the installation guide.
•
is improperly repaired or altered.
•
is subjected to misuse, negligence, and improper
installation where the guidelines were not
followed.
•
is used in a contradictory manner to the
instructions provided.
•
is a result of normal wear and tear.
8.2 Symbols, Abbreviations, and
Conventions
°
C
Degrees Celsius
°
F
Degrees Fahrenheit
AC
Alternating current
AWG
American wire gauge
DC
Direct current
EMC
Electro magnetic compatibility
ETR
Electronic thermal relay
FC
Frequency converter
IP
Ingress protection
LCP
Local control panel
MCT
Motion control tool
MDCI
C
Multi-drive control interface
PCB
Printed circuit board
PELV
Protective extra low voltage
PM
Motor
Permanent magnet motor
RCD
Residual current-operated protective device
Regen Regenerative terminals
RFI
Radio frequency interference
RPM
Revolutions per minute
Table 8.1 Symbols and Abbreviations
Conventions
Numbered lists indicate procedures.
Bullet lists indicate other information and description of
illustrations.
Italicized text indicates:
•
Cross-references.
•
Links.
•
Parameter names.
All measurements are given in both metric units and
imperial units. Imperial units are in ( ).
Appendix
Installation Guide
MG37K302
Danfoss A/S © 08/2017 All rights reserved.
67
8
8