2.2.8 Quick Menu, Q4 SmartStart
SmartStart runs automatically on the first power-up of the
frequency converter or after a reset to factory settings.
SmartStart guides users through a series of steps to ensure
the correct and most efficient motor control. SmartStart
can also be started directly via the
Quick Menu
.
The following settings are available via SmartStart:
•
Single pump/motor
: In open loop or closed loop.
•
Motor alternation
: 2 motors share 1 frequency
converter.
•
Basic cascade control
: Speed control of a single
pump in a multi-pump system.
For example, this can be a cost-effective solution
in booster sets.
•
Master/slave
: Control of up to 8 frequency
converters and pumps to ensure smooth
operation of the overall pump system.
2.2.9 Main Menu Mode
Press [Main Menu] to enter the main menu mode. The
readout in
appears on the display.
The middle and bottom sections in the display show a list
of parameter groups, which can be selected by toggling
the [
▲
] and [
▼
] keys.
e30bp066.14
0-** Operation/Display
1-** Load/Motor
2-** Brakes
1107 RPM 3.84 A
Main Menu
1(1)
3-** References/Ramps
Illustration 2.15 Main Menu Mode
Each parameter has a name and number, which remain the
same regardless of the programming mode. In the main
menu mode, the parameters are divided into groups. The
first digit of the parameter number (from the left) indicates
the parameter group number.
All parameters can be changed in the Main Menu.
However, depending on the configuration
(
parameter 1-00 Configuration Mode
), some parameters can
be hidden. For example, open loop hides all the PID
parameters, and other enabled options make more
parameter groups visible.
2.2.10 Parameter Selection
In the main menu mode, the parameters are divided into
groups. Select a parameter group with the navigation keys.
After selecting a parameter group, select a parameter with
the navigation keys.
The middle section on the display shows the parameter
number and name, and the selected parameter value.
130BP067.10
740RPM
0 -01 Language
[0] English
10.64A
1 [1]
0-0*
Basic Settings
Illustration 2.16 Parameter Selection
2.2.11 Changing Data
The procedure for changing data is the same in the quick
menu mode and the main menu mode. Press [OK] to
change the selected parameter.
The procedure for changing data depends on whether the
selected parameter represents a numeric data value or a
text value.
2.2.12 Changing a Text Value
If the selected parameter is a text value, change the text
value with the [
▲
] [
▼
] keys.
Place the cursor on the value to save and press [OK].
130BP068.10
740RPM
0 -01 Language
[0] English
10.64 A
1 [1]
0-0*
Basic Settings
Illustration 2.17 Changing a Text Value
How to Program
Programming Guide
MG20OB02
Danfoss A/S © 05/2018 All rights reserved.
21
2
2
Содержание VLT AQUA Drive FC 202
Страница 2: ......