Danfoss VACON NX, Инструкция по применению

Страница: 92 / 360

Index Parameter Min Max Unit Default ID Description
8 = Keypad
9 = Fieldbus
P2.1.14 Jogging speed refrerence 0.00
P2.1.2
Hz 5.00 124 See 10.157 (ID 413) Jogging Speed
P2.1.15 Preset speed 1 0.00 P2.1.2 Hz 10.00 105 -
P2.1.16 Preset speed 2 0.00 P2.1.2 Hz 15.00 106 -
P2.1.17 Preset speed 3 0.00 P2.1.2 Hz 20.00 126 -
P2.1.18 Preset speed 4 0.00 P2.1.2 Hz 25.00 127 -
P2.1.19 Preset speed 5 0.00 P2.1.2 Hz 30.00 128 -
P2.1.20 Preset speed 6 0.00 P2.1.2 Hz 40.00 129 -
P2.1.21 Preset speed 7 0.00 P2.1.2 Hz 50.00 130 -
1
Parameter value can only be changed after the AC drive has been stopped.
7.4.3 Input Signals
Table 56: Basic Settings (Control Panel: Menu M2 -> G2.2.1)
Index Parameter Min Max Unit Default ID Description
P2.2.1.1
(1)
Start/Stop logic 0 7
-
0 300
Logic = 0
Ctrl sgn 1 = Start forward
Ctrl sgn 2 = Start reverse
Logic = 1
Ctrl sgn1 = Start/ Stop
Ctrl sgn 2 = Reverse
Logic = 2
Ctrl sgn 1 = Start/ Stop
Ctrl sgn 2 = Run enable
Logic = 3
Ctrl sgn 1 = Start pulse (edge)
Ctrl sgn 2 = Stop pulse
Logic = 4
Ctrl sgn 1 = Start
Ctrl sgn 2 = Motor potentiometer UP
Logic = 5
Ctrl sgn 1 = Forward pulse (edge)
Ctrl sgn 2 = Reverse pulse (edge)
Logic = 6
Ctrl sgn 1 = Start pulse (edge)
Ctrl sgn 2 = Reverse pulse
Logic = 7
Ctrl sgn 1 = Start pulse (edge)
AB296635287482en-000301 / DPD00903 92 | Danfoss A/S © 2023.02
Multi-purpose Control Application
VACON® NX All-in-One
Application Guide