Assembling OSPE (continued)
Press and turn the shaft seal (7) into position in the
housing.
Draw the inner and outer parts of the assembly tool out
of the steering unit bore, leaving the guide from the
inner part in the bore.
With a light turning movement, guide the spool and
sleeve into the bore.
Fit the spool set holding the cross pin (12) horizontal.
The spool set will push out the assembly tool guide. The
shaft seal (7) is now installed.
Place the steering valve housing (3) on the holding tool
on the steering column end.
Service Manual
OSPE Steering Valve
Assembly
L1506577 • Rev 0001 • August 2015
29
