4
VIIFR102 © Danfoss 03/2014
Installation manual
Danfoss Link™ HP kit
Installation, HP kit for Danfoss DHP-H/L/A
The HP kit’s main components comprise a GateWay card, fitted inside the heat pump, and a DCM03, which
communicates wirelessly with the other parts of the heating system.
Danfoss Link
™
CC is used to control the system. Ensure that this control unit has the latest software
installed to avoid problems when installing the HP kit.
1. Check the software version on the control unit display. Press the left arrow
on the heating pump control until the display changes to “Service menu”.
2. Press “minus” until the cursor reaches the “Version” menu.
3. Press the “right arrow”. This will bring up the software version in the display.
Danfoss Link
™
to
DHP-H/L/A requires software version 1.34 or later.
Contents
Verify the contents of the HP kit. The delivery must contain the
following:
Description
Quantity
DCM03
DCM03 cable
GateWay (incl. power cable)
GateWay cable
Mounting clips
This manual
1
1
1
1
4
1
Mount the GateWay card inside the heat pump on the prepared holes in the electrical panel. The DCM03
unit must be positioned outside the heat pump in order to be able to communicate wirelessly with
Danfoss Link
™
CC. The DCM03 unit must not be installed on the heat pump as the metal cabinet may
suppress the wireless signals. A network test will show if the location provides the necessary signal
conditions.
Fitting the GateWay card
Location
Safety precautions
C
Installation must be carried out in accordance with applicable laws and regulations, as well as
these instructions.
C
The terminal blocks are live and can be highly dangerous due to the risk of electric shock. The
power supply must be disconnected before commencing electrical installation.
≥ 2.2
Service menu
- Installation
- Version
+
_
<
>
1
2
3
!
1. Open the cover by turning the open/close mechanism, after which the
cover can be lifted off. Be careful with the display cable behind the
cover.
≥1.34
or later
