WARNING!
Risk of squeezing!
When the die system closes, there is a risk of getting squeezed
between the die and the workpiece.
• Keep the feed opening for the workpiece as small as possi-
ble.
• Keep a minimum distance of 120 mm (A) to the die system.
1.
Press
the button to activate the dual foot switch.
2.
Manually position the pre-mounted workpiece in the tool.
3.
Hold the workpiece with one hand during the forming process.
4.
Activate and hold the dual foot switch.
5.
Manual operation mode:
When the forming process is comple-
ted, release the foot switch >Close< and activate the foot switch
>Open< to open the tool.
6.
Semi-automatic operation mode:
Wait until the hold time defi-
ned in the control has expired; the tool will then open automati-
cally.
7.
Remove the workpiece from the tool.
8.
Check the forming dimension after the first forming process.
Correct the forming dimension in case of deviations between the
actual dimension and the specified dimension (see "Setting the
forming dimension" in Section 5).
The operation mode Remote automatic via the dual foot switch is
only functional if the plug of the dual foot switch is connected to the
control cabinet.
Содержание ET4500-002
