Danfoss
ET4020 Crimp Machine Operator’s Manual
6 | © Danfoss ET4020 Crimp Machine Operator’s Manual | 2022.12.
AQ435956026217en-000101
Operating the Keypad (cont.)
3.
The ENTER button is used to put any three-digit number into the
DISPLAY. The green light next to the ENTER button will illuminate when
you are working in the ENTER mode.
4.
The numbered keys have two functions:
a
In the Enter mode, their numeric value is put into the DISPLAY.
b.
In the STORE mode, they act as 10 different locations in which to
store a DISPLAY setting.
Entering a Number into the Display
1.
Turn the power control switch on the back of the crimp machine to
the ON position. The work light and the DISPLAY will illuminate to
show that the power is on.
2.
Press the ENTER button (the green light next to the ENTER button will
illuminate).
3.
Press three numerical buttons in less than five seconds. (If more than
five seconds elapse, the display reverts back to its previous setting.)
After the third number is entered, the display will remain.
4.
The ET4020 is now ready to crimp to the DISPLAY setting.
Storing a Number from the Display as a Preset
1.
Enter a three-digit number as described in the procedure above.
2.
Press the STORE button. (The green light next to the STORE button will
illuminate.)
3.
Press and hold down any one of the ten numerical buttons for three
seconds. (At the end of three seconds, the green light next to button
will illuminate, indicating that the display has been stored to that
button.)
Recalling a Preset into the Display
1.
Make sure that the STORE and ENTER lights are off. (If one is on, it will
go off in five seconds if left untouched.)
2.
Press the button that has the stored setting for a given hose and fitting
style. This setting will then be seen in the DISPLAY.