© Danfoss A/S (RC-MDP/MWA), 2014-08
DKRCI.PI.RP0.C1.02 / 520H8794
7
ENGLISH
Menu’s
Entrance to menu’s (see fig. 10)
From Home Image the status menu can be
reached by one push on . From Home
Image the Setup & service menu can be
reached by one push and hold on .
For entrance a Log in is required by the
password given during commisioning.
Parameter mode (read/write mode)
When maneuvering in Setup & service
menu or Status menu there is an overall
logic of showing possible actions for each
parameter.
Plain text:
Read only
Framed text:
Parameter can be changed - push to
highlight.
Highlighted text:
Scroll with / to the desired selection
and push to enter the selection.
Once entered the parameter is valid and
the text changes to framed text.
Status menu
To enter Status menu from Home image:
Push once.
The Status menu is an open menu acces-
sible for all. Therefore only 1 parameter
can be changed from here. A selection of
other parameters can be seen from the
status menu:
Status menu ( Open menu )
Options
Setpoint
Liquid level setpoint
0 - 100%
Active alarms
Example of alarm content. The list will be empty in
normal operation as no alarm is active.
Level signal out of range
hours
minutes
Standby mode
hours
minutes
Detailed status
Controller state
Stop, Manual, Auto,
Slave, IO
Actual level
0.0 - 100%
Actual reference
0.0 - 100%
Actual OD
0.0 - 100%
Digital input status
On / Off
Actual level signal current
mA
Oscillation amplitude
0.0 - 100%
Oscillation period
sec
Controller Info
Type
Name (Controller name)
SW (Software version)
Bios (Bios version)
Adr (Controller address)
SN (Serial Number)
PV (Product version)
Site (Production site)
QR code
Code
Read & Write
Read only
Setup & service menu
(Requires log-in password assigned in
Commisioning menu)
To enter Setup and service menu from
Home image:
Push and hold .
Maneuvering in the Status menu and the
Setup and service menu’s are done by use
of the 4 push buttons shown in fig. 8.
The Setup & service menu is divided into
3 access levels, where personnel have
individual authority.
Most advanced level is
Commissioning
,
where you have access to change all
allowable parameters, including password
issuing and re-run of Setup wizard. Default
password for commissioning is 300.
Service
level is for service personnel and
has fewer rights than commissioning.
Default password is 200.
The lowest level is for
Daily
use, and allows
only a few changes. Default password is
100.
Below table shows authority given to the
3 levels.
