Danfoss ECtemp Touch, Руководство по установке

Страница: 8 / 24

Danfoss ECtemp Touch
Installation Guide 8
Follow the steps below to mount the thermostat:
1. Open the thermostat:
Important:
Do NOT press on the display screen when
removing the front part.
Press your fingers under the side of the front part and
pull toward you:
2. Connect the thermostat according to the connection
diagram.
The screen of the heating cable must be connected to
the earth conductor of the power supply cable by
using a separate connector.
Note:
Always install the floor sensor in a conduit in the
floor.
N
IP21
T30
Dtouch
Mains
220-240V
50-60 Hz
Maximum
Load 16 (1) A
Sensor
Standby maximum 0.4W
L
L
L
O
A
D
NTC
N
L
O
A
D