Danfoss DHP-R 7UA HPC EM, Руководство по установке

Страница: 11 / 16

VMBQI102
VMILF102
Danfoss – 11
Cooling module, HPC CM
The operational description for the cooling module is available in the controller manual .
Installation
Application
The cooling module controls the temperature of a cooling using a pilot valve . The cold is collected from a cooling tank,
which is cooled with active or passive cold .
Passive cold means that cooling agent fluid is circulated through the drill hole and the cooling tank, without activation
of any heating pump. Only circulation pumps for cooling agents are used. The heat from the cooling tank is transported
down into the mountain . An assumption for passive cooling to work is that the cooling agent fluid is colder than the coo -
ling tank .
Active cooling means that a heat pump is activated to lower the temperature of the cooling agent, before it is transferred
into the cooling tank . If the cooling integral continues to rise, more heat pumps are started . The valve for active cooling
changes its mode and disconnects the drill hole . Therefore, the cooling agent only circulates through the cooling tank and
heat pump, so that all the produced cold can be collected .
Additionally, a dew point control function can be activated in the cooling module . This function is not necessary, but if it is
used a dew point sensor must be connected .
Surplus heat produced during active cooling can either be returned to the drill hole or cooled in a coolant cooler . If a
coolant cooler is used, a temperature sensor is connected for the cooler and the coolant module then controls the cooling
fans .
Required accessories
4 PT1000 contact strap-on temperature detector with 2 m of cable, item no. 086U3365 (item number corresponds to 1
detector)
One of the following modular cables:
Modular cable 0.3 m, item no. 086U4227
Modular cable 1.1 m, item no. 086U4228
Modular cable 10.0 m, item no. 086U4229
Connection block, item no. 086U5121
Dew point sensor for wall mounting, item no. 086U3396 (if the dew point function is used)