Installation Guide
Ready-made self-limiting cable DEVIpipeheat™ 10 V3
7
Typical installations
7.1
Typical pipe tracing installation
On water pipe installation
1
2
3
4
5
Fig 1
1 Apply aluminum tape below (mandatory for
plastic pipes) and on top on the whole length
of the cable
2 Insulate the pipe with at least 30 mm insula-
tion or thicker if required based on heat loss
calculation
45°
90°
45°
90°
45°
90°
45°
90°
1
3
Fig 2
1 - Heating cable; 2 - Aluminum tape; 3 - Wire sensor; 4 - Insulation; 5 - Warning label/tape
In water pipe installation
1
2
3
4
5
6
Fig 3
1 Fit a T-shaped pipe of a generous size over the pipe
(3/4" and 1")
2 Fit the clean wadding (without side thread or sharp
edges) inside the T-shaped pipe with small hole in
the center
3 Keep the cable clean and push the cable through
the wadding to facilitate the installation The con-
nection between heating cable and connecting
cable must be outside the wadding Mount the
wadding in the following sequence:
• use only clean tools before installation as
heating cable could be in contact with drinking
water;
• first you put the nut on facing the connection;
• mount the washer on the cable;
• mount the threaded part with the threaded part
facing the end of the cable;
• insert almost whole length of the cable inside of
the pipe, leave approx 0,5 m of cable to install
rubber seal afterwards;
• the heating cable must extended straight
through the T-shaped pipe;
• install rubber seal on the cable The conic rubber
seal has slice for heating cable
4 Turn the nut until it fits tightly (max torque for pipe
fitting is 30 N·m)
5 Insulate the pipe with at least 30 mm insulation or
thicker if required based on heat loss calculation
1 - Heating cable; 2 - Aluminum tape; 3 - Wire sensor; 4 - Insulation;
5 - Warning label/tape; 6 - 3/4" + 1" Pipe fitting
9
DEVI