Aeroquip FT1360 Crimp Machine Operator’s Manual
AQ453358079899en-010101
© Danfoss | Aeroquip FT1360 Crimp Machine Operator’s Manual | 2023.06. | 7
Specifications
Dimensions
32” wide, 42” deep, 50” high
Weight
2,000
lbs.
Motor
10
HP
Electrical Requirements
230/460 volts, 60 Hz, 3 phase
Pump
15 gpm to preset limit, 2 gpm to 3,000 psi
Reservoir
10 gallon, SAE 10W hydraulic oil
Hose
-4 through -40 textile and wire reinforced, through -32 six wire spiral
Installation
The FT1360 crimp machine is delivered completely plumbed and wired. The reservoir has been filled with 10 weight hydraulic oil.
1. Uncrate the machine and position it in its work location on a floor capable of supporting a machine weighing 2000 pounds.
2. Position the disconnect switch to the “OFF” position.
3. The transformer in electrical box is wired for 460 volts.
4. The machine comes wired for 460 volts. Thermal overloads and fuses are provided for conversion to 230 volts. Consult Danfoss with
any questions regarding assistance with conversion procedures.
*5. Install 460 volt power into the disconnect.
* If the FT1360 crimp machine fails to operate properly, 2 of the incoming disconnect 3Ø lines must be switched.
Tooling
Crimp Die Cages:
Crimp dies for the FT1360 crimp machine are contained in a die cage which can be inserted as a package into the
machine, thus eliminating time consuming and inaccurate insertion of individual dies. Each set of eight crimp dies is contained in a
separate die cage, thus eliminating concern from inter-mixing dies of different sets.
Crimp die cage part numbers are similar to crimp die part numbers. In either case the die suffix number is the same. Use the PowerSource
Crimp Spec tool to determine the tooling that should be used. The FT1209 crimp dies are longer than the FT1307 dies. They will
accommodate the longer sockets required with these assemblies.
