the bracket. When correctly assembled, the
2 grounhd bars mirror each other.
2.
Remove 4 screws from the mounting holes in the
midplate, 2 from each side of the drive. For the
location of the mounting holes, see
Illustration 1.1
.
3.
Position the 2 angle brackets with attached ground
bars over the mounting holes in the midplate. See
Illustration 1.3
.
4.
Fasten angle brackets to the midplate with 4 M5x18
mm screws (T25) from the kit, 2 in each angle
bracket. Tighten to 2.3 Nm (20 in-lb).
1
Mains side ground bar installed
2
Motor side ground bar installed
Illustration 1.3 Ground Bars and Angle Brackets Installed
Installation Instructions
Ground Bar Kit for E1h/E2h Drives
VLT
®
FC Series FC 102, FC 103, FC 202, and FC 302
4
Danfoss A/S © 10/2017 All rights reserved.
MI35K102
