Danfoss 176F4184, Руководство по установке

Страница: 6 / 14

1.
2.
- a.
- b.
-
c.
3.
- a.
-
b.
-
c.
-
2.4 Installing the Base Plate
Use the following steps to attach the base plate and cable entry plate to the frequency converter. See Illustration 4 and Illustration
5 .
Procedure
Unfasten 8 M5x12 screws (T25) from the existing cable entry plate (gland plate), and remove the plate from the bottom of
the frequency converter.
Keep the screws for installation of the new cable entry plate.
Attach the base plate:
Adhere the base plate gasket to the upper side of the base plate.
Position the base plate at the bottom of the frequency converter.
Secure the base plate using 6 M5x12 screws (T25) from the kit.
e3
0b
k8
40
.1
0
Illustration 4: Base Plate Installation
Install the cable entry plate:
Cut holes in the cable entry plate for the glands (not provided).
Adhere the cable entry gasket to the upper surface of the cable entry plate.
Position the cable entry plate over the opening in the base plate below the mains and motor terminals.
AN440656954288en-000101 / 136R0326 6 | Danfoss A/S © 2023.09
Installation
In-back/Out-back Cooling Kit for FK09a/FB09a and FK10a/FB10a
Installation Guide