Connect instrument cable to the IN jack. Battery power is
activated when cable is connected to IN jack. Connect
amplifier cable to the OUT jack. If using Danelectro AC
Adaptor, connect to DC 9-Volt jack.
LED light will be on when foot switch is activated.
Control Functions:
MIX:
Use to select the mix of dry to echo/delay signal.
HI-LO:
Use to set long (Hi) or short (Lo) echo/delay times.
SPEED:
Use to select the length of echo/delay within the
HI or LO speed range selected.
REPEATS: Use to set the number of repeats.
HI CUT:
Cuts the high frequency on the delayed signal.
Each successive repeat suffers further high
frequency cut. This simulates a vintage tape
echo.
Dan-Echo
DE-
1
I
NSTRUCTIONS
•
•
•
BATTERY: Uses one S-006P 9-Volt Battery. Danelectro “Vintage Power Source”
batteries are recommended.
Battery Eliminator: Uses 9-Volt battery eliminator. Polarity: Center negative (–) adaptor
plug. 300mA maximum. Danelectro Zero Hum
™
DA-1 Adaptor is recommended.
TM
S
OLO
D
ELAY
CONTROL SETTINGS
MIX
SPEED
LO-HI
REPEATS
HI-CUT
Содержание Dan-Echo
Страница 1: ...Dan Echo Tape Echo OWNER SMANUAL TM ...
Страница 10: ...ROCKABILLY CONTROL SETTINGS MIX SPEED LO HI REPEATS HI CUT ...
Страница 17: ...Dan Echo DE 1 TM ...
Страница 18: ... EC 2000 Printed in China DE 1 ...