16
9
In case your locomotive is not equipped with an interface jack, the decoders must be wired individually. For this
purpose you should use the decoders with flexible wires (DH05C-
3
, DH10C-
3
, DH16A-
3
, DH21A-
3
, PD05A-
3,
PD12A-
3
).
10 The decoders DH05C-
0
, DH10C-
0
, DH16A-
0
, DH21A-
0
, PD05A-
0
and PD12A-
0
should be used by experienced
model railroaders only, as the connection wires must be soldered directly onto the decoder.
For above variant 9 connect the decoder wires according to the following diagram (see also the chart on the following
page):
red wire
with the right track wire
black wire
with the left track wire
orange wire
with the motor wire, which was connected to the right track wire
gray wire
with the motor wire, which was connected to the left track wire
white wire
with the front light in driving direction
yellow wire
with the rear light in driving direction
green wire
function output AUX1 (only DH16A-
2/3
and DH21A-
2/3
)
violet wire
function output AUX2 (only DH16A-
3
and DH21A-
3
)
blue wire
common return, can carry up to 30 volts (
+
VS) (only DH16A-
2/3
und DH21A-
2/3
)
In addition for SUSI-interface (only if available):
red wire
SUSI-supply voltage (ZVS)
blue wire
SUSI-clock (ZCLK)
gray wire
SUSI-data (ZDAT)
black wire
SUSI-ground (GND)
Содержание DH05C
Страница 68: ...68 Blank page for your notes...
