Assembly
NOTICE!
Only use the supplied and specified screws
[2], otherwise there is
a risk of damaging the threaded inserts.
Always use the spring washers
[3] and U washers [4] to prevent
the bolts from slackening.
Always place the rubber pads
[5] between the bracket and the
cabinet to prevent the cabinet coating from scratching during
assembly and adjustment.
Tools required:
▪ Open-ended spanner/wrench (size #17)
1. Starting on one side, first align one hole of the rubber pad
with one threaded insert.
2. Insert one screw together with the spring and U washers.
3. Align the second hole of the rubber pad with the second
threaded insert.
4. Insert the second screw together with the spring and
U washers.
5. Tighten both screws.
↳This will simplify the attachment of the rubber pad on the
opposite side.
6. On the opposite side, proceed in the same manner.
1.6 Z5555 Adjustments
To align the cabinet to its desired angle, proceed as follows:
1. Slightly slacken all screws.
2. Align the cabinet to its desired angle.
3. Finally tighten all screws.
d&b Z5555/Z5556 Mounting instructions 1.2 en
7
