Rigging/Derigging
Attach the Flying adapter according to the type of assembly
(single, 2-, 3-, or 4-wide).
For this purpose, use the enclosed hand bolts
[2] and hand-tighten
them properly.
With ALi60/ALi90 cabinets use the enclosed hex head screws
(M10 x 25 - Wrench SW17)
[2a] and U-washers (10.5) [2b].
5. Rig the cabling
Connect the flying cables and link cables according to the number
of amplifier channels and cabinets used. Observe the related
loudspeaker setups for the inner (In) and outer (Out) cabinets.
6. Check the assembly
Before hoisting the array to its operating position, recheck the
entire assembly.
3.3 Hoisting and securing the array
When all the mechanical adjustments, system checks, and safety
checks have been made, the array can be hoisted up to its
operating position.
When hoisting the array, ensure that the loudspeaker cables do
not get caught anywhere. The cables can be strapped together
with the motor cable to form a loom while the system is hoisted.
The chain hoist motors must raise the system slowly and evenly so
that it does not swing or move from side to side during hoisting.
When the array is in its final operating position, a secondary safety
device must be applied.
3.4 Derigging
The same safety instructions apply!
To dismantle any of the assemblies, follow the corresponding
rigging and setup instructions in reverse order.
d&b Z5456 Rigging manual 1.1 en
14
