Rigging/Derigging
2. Set the splay angles
The splay angles between adjacent cabinets are set on the central
rear rigging strands of the cabinets and can be set in the range
from 20° to 40° in 5° increments.
Select the splay angles according to your ArrayCalc simulation.
Depending on the desired splay angle, set the Splay link to the
"Standard" or "Extended" length as described in
"Setting the splay angle(s)" on page 9.
1. At the rear, release the Locking pins on all cabinets.
2. Fold out the Splay links.
4. Align the Splay link with the corresponding hole for the
desired splay angle.
5. Insert the respective Locking pin and ensure the pin is fully
inserted and properly locked.
3. Splay link of the last cabinet
To avoid either rattling during operation or damage to the Splay
link of the last cabinet, we recommend you to remove the Splay
link and store it temporarily in a safe place. To remove the Splay
link, proceed as follows:
1. Release and remove the ring cotter
[1] of the fixing bolt.
2. Remove the fixing bolt
[2] and Splay link [3].
4. Attach the Flying adapter
Adapter positions
Depending on the type of assembly (single, 2-, 3-, or 4-wide) the
Flying adapter is attached directly to the top panel of one cabinet
(single and 3-wide) or over two cabinets (2- and 4-wide), as
shown in the graphics below.
Single
2-wide
3-wide
4-wide
d&b Z5456 Rigging manual 1.1 en
13
