2
3
5.3 Pediments
The plans for the marquee pediment consist of 2 pediment covers, an
eyelet and a loop side. The inner side of the marquee is marked with
visible suture of the loops and the overlaps of the side, which forms the
right angle, is covered and welded inward.
5.3.1
Insert the pediments with the piping into the upper piping channel of
the pediment bar and pull to the centre of the pediment with assembly
fork (image 12, page 22)
5.3.2
Tie both the pediment covers from top to bottom to the inner side of
the marquee as described in point 5.2.6 and knot last loop (image 12,
page 22).
5.3.3
Place the buckle straps or loop fastener in the lower edge around
the crossbeam / curtain pipe and close.
5.3.4
Repeat points 5.3.1 to 5.3.2 on the opposite pediment side.
5.4 (If required) Assembling the foot tubes
The foot tubes for the side and pediment covers are available as
accessory for each
marquee and installation is recommended.
5.4.1
The foot tubes are inserted through the foot tube of the side
curtains (Image 13, page 24).
5.4.2
Push the foot tube on the pin of the marquee post and secure with
splint pin.
5.4.3
Insert the foot tube on the pediment side into the foot tube pocket of
the pediment curtains.
5.4.4
Likewise, place the foot tube into the intake bolts of the foot plate
at the corner and secure with splint pin.
