8
Installation Instructions - Intergrated Application
Preparing the
Enclosure
FOR YOUR SAFETY:
While performing
installations described in
Tools You Will
Need
Electrical Requirements:
The appliance must be
connected to an individual
properly grounded electrical
•
It is recommended that you do
not install the wine cooler into a
corner (i.e. directly beside a
wall). This is to allow the door(s)
to have a greater than 90° open-
ing swing. A limited door swing
will prevent the shelves from
sliding out as intended, and may
lead to damaging the door gas-
ket(s).
•
The rough cabinet opening
must be on a level floor area
wide. The opening should also
•
The electrical outlet may be
positioned from within either
side of the adjacent cabinetry, or
the rear of the shaded area (as
shown in Fig C.).
Important:
If the electrical out-
let is surface mounted (not flush)
within the enclosure, the
depth
requirment for the installation
will be affected.
•
If the electrical outlet is located
inside the adjacent cabinetry, cut
a 1-1/2” diameter hole to admit
Electrical Access
Fig C
Cabinets
Square
and
Plumb
Underside of
Countertop to
Floor
24”
6”
2”
Min*
1-1/2” dia. hole
*if electical outlet
is in adjacent
cabinetry
this section, gloves and
safety glasses or goggles
should be worn.
outlet, by a 15 or 20 ampere
delay fuse.
circuit breaker or time
and at least 26” deep
*
by 24”
26”
have a height of at least 34-7/16”.
34-7/16”
From
the power cord. If the cabinet wall
is metal, the hole edge must be covered
with a bushing or grommet.
