Occasionally, a problem may arise that is minor in nature, and a service call may not be necessary.
Use this troubleshooting guide for a possible solution. If the unit continues to operate improperly, call
an authorized service depot or
Danby’s Toll Free Number 1-800-263-2629
for assistance.
Problem
Possible Cause
What to do
No power
• A fuse in your home may be
blown or the circuit breaker
tripped.
• Power
surge.
• Plug not fully inserted into
the wall outlet.
• Replace fuse or reset circuit breaker.
• Unplug the wine cooler, wait a few
seconds and then plug it back in
• Make sure the 3-prong plug is fully
inserted into the outlet.
Cabinet temperature
is too high.
• Temperature
setting.
• Door not shut properly or
opened excessively.
• Recently added a large
quantity of warm bottles to
the cabinet.
• Verify the temperature control setting.
Adjust if neccessary.
• Ensure that the door is fully closed
and that the gasket is sealing against
the cabinets. Open the doors only as
needed and for short periods of time.
• Limit the quantity of warm bottles
being introduced to the cabinet at the
same time. Attempt to stagger the
load introduction if possible.
Condensation on
the cabinet, doors or
fl oor.
• High humidity conditions in
the home.
• Door not shut properly or
opened excessively.
• The condensation will subside once
humidity conditions return to normal.
• Ensure that the door is fully closed
and that the gasket is sealing. against
the cabinets. Open the door only as
needed and for short periods of time
Wine cooler runs
continuously.
• Temperature set too cold.
• Door is not closed.
• Door opened too long or too
often.
• Close proximity to heat
source or direct sunlight.
• Adjust temperature to warmer setting.
• Close door securely.
• Minimize door opening duration and
frequency.
• Do not place unit close to heat
sources or direct sunlight.
Troubleshooting
9
