Remove and save screw that holds
blower motor to microwave.
Back of
Microwave
Blower Motor
Blower Motor
Screw
B3
PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
INSTALLATION INSTRUCTIONS
Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate through
the holes designated to go into drywall and reat-
tach the toggle wings to 3/4’’ onto each bolt.
1
2
Attach the plate to the wall using toggle bolts. At least one
wood screw must be used to attach the plate to a wall
stud.
Wall
Mounting
Plate
Spacing for Toggles More
Than Wall Thickness
Toggle
Bolt
Toggle Wings
Bolt End
TO USE TOGGLE BOLTS
Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE:
Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the bot-
tom of the cabinet when pushed flush against the wall and
that the plate is properly centered under the cabinet.
Be careful to avoid pinching fingers between the back of the
mounting plate and the wall.
CAUTION
Tighten all bolts. Pull the plate away from the wall to
help tighten the bolts.
3
4
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE
Wear safety goggles when drilling holes in the cabinet bottom.
CAUTION
B4
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
B5
1
2
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust the
blower unit
.
BEFORE: Fan Blade
Openings Facing Up
End B
End A
16
