OPERATING INSTRUCTIONS
Instructions for Use
11
The drying temperature is selected automatically
by the selection of the drying program, and it is
lower for delicate laundry than for the resistant
one. During the drying program with preset time
the temperature is the same for both the delicate
and resistant laundry.
Drying stage indicator
Damp for machine ironing
Damp for ironing
Mildly damp
Dry for storage
Very dry
Anti crease
End
The drying stage indicator displays the actual
drying stage at any given moment. This is
signaled by the indicator light, illuminated
adjacent to a particular drying stage symbol. The
end of drying is signaled by the indicator light
END or ANTI-CREASE.
START button
This button starts the operation of the appliance.
In case of program interruption (open door,
voltage failure, condensation receptacle full), it
serves to continue the actual program, after the
cause for interruption had been removed.
Drying
Drying time depends upon the selected program
and the quantity of laundry. If you selected time
defined drying the machine stops upon the expiry
of set time. If you selected any of the programs
for automatic determination of moisture, drying
time will largely depend upon the quantity of
laundry and the extent of moisture present in the
laundry (after the final spin stage of the wash
program).
Actual stage of moisture during the program is
indicated by the moisture stage display, so you
may remove particular pieces of clothing you
wish to remain damp at any time during the
program. When you open the door (add or
remove pieces of laundry) the drying program
stops automatically and the drum interior is
illuminated. When you close the door the light
goes off and the program continues by pressing
the START button.
In case of a power failure during a selected
program, the drying operation stops. When the
power is reinstated, you must to press the
START button to continue the program.
Each program concludes with a 10 minute
cooling down period, to prevent extracting hot
laundry from the appliance and to improve the
anti-crease function.
Drying programs are complete when the signal
beep sounds and the indicator light “END” and
“ANTI-CREASE” illuminate at the end of the
program. This indicates that the laundry is dried
to the point of the preset moisture stage, or the
preset drying time has expired. The drum stops
and laundry may be removed from the machine.
NOTE: If the laundry is not removed immediately
after the drying cycle is completed, (and the
machine is not switched off) the dryer will
automatically start a special anti crease program.
ANTI-CREASE PROGRAM: Consist of:
•
5 minute “OFF” (dormant) cycle
•
5 second “ON” tumbling cycle (ho heat)
This program helps to prevent laundry from
sitting idle in the same position and helps to
reduce creasing/wrinkling. The “anti-crease”
program stops automatically after one hour of
operation, but may be interrupted at any time by
opening the door or turning the appliance off.
After drying
•
Open the dryer door. Remove and clean the lint
filter. If the filter is not cleaned regularly, the air
circulation is obstructed. This obstruction will
increase the drying time and may cause the
unit to overheat and fail.
•
Reinsert the filter.
•
Remove laundry from the drum.
•
Close the door and disconnect the power
supply.
