Danaher Motion DBL Series, Руководство пользователя

Страница: 15 / 72

The following notes should help you to carry out the assembly and wiring in an appropriate se-
quence, without overlooking anything.
The site must be free of conductive and aggressive material.
For V3-mounting (shaft end upwards), make sure that no liquids can
enter the bearings. If an encapsulated assembly is required, please
consult our applications department beforehand.
Ensure an unhindered ventilation of the motors and observe the
permissible ambient and flange temperatures.
For ambient temperatures above 40°C please consult our applications
department beforehand.
During assembly, take care that the motor is not overstressed when it
is fixed in place.
Select cables according to EN 60204
See the table in chapter II.1 when cable length exceeds 25m.
Use correct earthing and EMC-shielding according to the Installation
Instructions for the servo-amplifier which is used. Earth the mounting
plate and motor casing. For connection methods see chapter II.2.1.
— Route power cables as separately as possible from control cables
— Connect up the resolver or encoder.
— Connect the motor leads, install motor chokes close to
— the servo-amplifier, connect shields to shielding terminals or EMC
— connectors at both ends
— Connect the holding brake, if used, Connect shielding at both ends.
Final check of the installed wiring, according to the wiring diagram
which was used
Motor series DBL/DBK 15
Danaher Motion
05/2001
Installation / Commissioning
Site
Ventilation
Assembly
Earthing
Shielding
Cable selection
Check
Wiring